Replacing The Battery; Troubleshooting; Nothing Is Indicated On The Lcd Display; Lo" Is Indicated On The Lcd Display And The Scales Switch Off - Silvercrest SPWD 180 D1 Bedienungsanleitung Und Serviceinformationen

SilverCrest SPWD 180 D1

Replacing the battery

Replace the battery when it is empty. To replace
the lithium battery CR2032, remove the cover
from the battery compartment (7) on the bottom of
the diagnostic scales by pressing the ribbed
surface with your finger and then sliding the cover
off sideways.
To remove the battery, push it down a bit (see the
direction of the arrow in the illustration). You can
then remove the battery from the holder.
Then insert a new lithium battery CR2032. Pay
attention to the polarity when inserting the battery.
This is indicated in the battery compartment (7),
and the + symbol on the lithium battery CR2032
must be visible, as shown in the adjoining
illustration.
Then replace the
compartment (7). The diagnostic scales are now
ready to use.

Troubleshooting

Nothing is indicated on the LCD display.


The lithium battery CR2032 is empty. Replace the lithium battery CR2032 with another of the
same type. Please note the instructions in the section "Replacing the battery".

The lithium battery CR2032 is inserted incorrectly. Please note the instructions in the section
"Replacing the battery".

"Lo" is indicated on the LCD display and the scales switch off.


The lithium battery CR2032 is almost empty. Replace the lithium battery CR2032 with
another of the same type. Please note the instructions in the section "Replacing the battery".
12 - English
cover on the battery