Replacing The Battery; Troubleshooting; Nothing Is Indicated On The Lcd Display; Lo" Is Indicated On The Lcd Display And The Scales Switch Off - Silvercrest SPWD 180 G1 Bedienungsanleitung Und Sicherheitshinweise

8.4 Replacing the battery

Replace the battery when it is empty. To replace
the lithium battery CR2032, remove the cover of
the battery compartment (7) at the rear of the
diagnostic scales by unlocking the locking
mechanism of the cover with your finger and then
taking the cover off.
To remove the battery, push it down a bit (see the
direction of the arrow in the illustration). You can
then remove the battery from the holder.
Then insert a new lithium battery CR2032. Pay
attention to the polarity when inserting the battery.
This is indicated in the battery compartment (7),
and the + symbol on the lithium battery CR2032
must be visible, as shown in the adjoining
illustration.
Then insert the 2 guide lugs of the battery
compartment cover back into the corresponding
slots and press the battery compartment cover until
the locking mechanism snaps into place. The
diagnostic scales are now ready to use.

9. Troubleshooting

9.1 Nothing is indicated on the LCD display

•
The lithium battery CR2032 is empty. Replace the lithium battery CR2032 with another of the
same type. Please note the instructions in the section "Replacing the battery".
•
The lithium battery CR2032 is inserted incorrectly. Please note the instructions in the section
"Replacing the battery".

9.2 "Lo" is indicated on the LCD display and the scales switch off

•
The lithium battery CR2032 is almost empty. Replace the lithium battery CR2032 with
another of the same type. Please note the instructions in the section "Replacing the battery".
SilverCrest SPWD 180 G1
English - 27