Installing The Drive Unit And Peripheral Parts; Installing The Drive Unit - Shimano STEPS EP800 Serie Gebrauchsanweisung

INSTALLING THE DRIVE UNIT AND PERIPHERAL PARTS

Installing the drive unit

INSTALLING THE DRIVE UNIT AND
PERIPHERAL PARTS
Use the following procedure to install the drive unit and peripheral parts.
(1) Installing the drive unit
(2) Wiring to the drive unit
(3) Installing the drive unit cover
(4) Installing the chainring unit and crank arms
TECH TIPS
• To check the wiring of the drive unit on a completed bicycle, you will need to first
remove the drive unit cover. Remove the left cover to access the power cord and
terminal block.
Installing the drive unit
Before installing the drive unit to the frame, first check that all electric wires and cables to
connect to the drive unit have been routed to the installation area of the drive unit.
1.
Secure the drive unit.
(1) Check the three mounting holes on the left and right of the frame.
(2) Tighten the mounting screw on the right side so that the drive unit makes firm
contact with the inner surface on the right side of the frame.
26