Installing Cockpit Peripheral Components; Installing The Battery Mount And Parts; Installing The Speed Sensor; Generic Type - Shimano STEPS EP800 Serie Gebrauchsanweisung

INSTALLING ELECTRICAL PARTS

Installing cockpit peripheral components

(2) Disconnect the electric wire from the E-TUBE port.
* As shown in the figure, use part (A) of the TL-EW02 as leverage for support and move it
like a lever, then disconnect it. If there is limited space to insert the tool, lift the TL-
EW02 straight up and disconnect the electric wire.
Installing cockpit peripheral components
Refer to the "SHIMANO STEPS Cycle Computer and Switch Unit Parts Dealer's Manual."

Installing the battery mount and parts

Refer to the "SHIMANO STEPS Special Battery and Battery Charger Parts Dealer's Manual."

Installing the speed sensor

NOTICE
• For details on the compatibility of the speed sensor and drive unit, refer to the
compatibility information (https://productinfo.shimano.com/#/com).

Generic type

For models: EW-SS300 (SD300 type)
The generic type speed sensor can be installed regardless of the type of brake, such as rim
brake, roller brake, or coaster brake. Set the magnet unit on a spoke on the rear wheel.
1.
Temporarily install the magnet unit to the spoke.
(1) Try pressing the speed sensor to the installation location on the frame, and determine
the installation location of the magnet so that the center of the magnet is aligned
over the tip of the triangle symbol.
(1) (2)
(A)
22