Making Walking And Pushing The Bicycle Easy (Walk Assist) - Shimano STEPS EP8 Originalbetriebsanleitung

„ Making walking and pushing the bicycle easy (walk assist)
SHIMANO STEPS has a function where assist works even when you are walking and pushing the assist bicycle.
• Depending on the region of use, you may not be able to use it due to the laws of the region. In this case, the operations
described here are disabled.
• This function cannot be used with bicycles that do not have assist switch installed.
1.
Stop and switch to walk assist mode.
Hold down the button (Y button) on the lower side of the assist switch (left side of the handle) until it reaches the
following state.
• Cycle computer: [WALK] is displayed
• Junction [A]: LED on the button side lights up in blue
• If nothing is done for one minute after switching to walk assist mode, it will switch back to the assist mode that was selected before
switching.
2.
Push the bicycle carefully while pressing the same button again.
If you let go of the Y button, the assist stops.
X
Y
Example of cycle computer
Example of junction [A]
X
Y
12