Manual Adjustment; Measuring And Adjusting Using The Chain Tension Measurement Tool - Shimano STEPS EP800 Serie Gebrauchsanweisung

INSTALLING THE DRIVE UNIT AND PERIPHERAL PARTS
Measuring and adjusting the chain tension

Manual adjustment

1.
Check and adjust the chain tension.
Pull the upper side of the chain up and down with a force of approximately 10 N (1 kgf),
roughly in the middle between the drive unit axle and rear wheel axle. Adjust the chain
tension so that the chain has a slack of 15 mm or more.
Measuring and adjusting using the chain tension
measurement tool
When using chain tension measurement tool TL-DUE60, you can measure and adjust the chain
tension from either the top or bottom of the chain.
`Measuring and adjusting from the upper side of the
chain
1.
Set TL-DUE60.
(1) Set TL-DUE60 to the upper side of the chain.
42