Affixing The Thermal Hazard Label; Installing The Chainring Unit And Crank Arms - Shimano STEPS EP800 Serie Gebrauchsanweisung

INSTALLING THE DRIVE UNIT AND PERIPHERAL PARTS

Installing the chainring unit and crank arms

Affixing the thermal hazard label

A thermal hazard label is affixed to the position shown in the figure on the guard (DC-EP800-G:
SHIMANO drive unit cover).
For bicycles that use custom covers from another company, refer to the position shown in the
figure to affix the thermal hazard label included with the DU-EP800 to a visible location around
the motor fins.
Installing the chainring unit and crank arms
Set the rear wheel to the bicycle prior to performing the procedures.
1.
Set the left crank arm.
(1) Check that the stopper plate on the left crank arm is sticking out.
(2) Set the left crank arm with the wide part of the spline on the left crank arm aligned
with the wide part of the spline on the crank axle.
Motor fins
Thermal hazard label
34