INSTALLING ELECTRICAL PARTS
Installing the speed sensor
Clearance between speed sensor
and magnet unit is 3 to 17 mm
Toothed washer
3.
Secure the magnet unit.
Magnet unit
Spoke
4.
Set the electric wire from the speed sensor along the chainstay to the
frame, and wire it to the drive unit.
Type designed exclusively for use with disc brakes
For models: EW-SS301 (SD300 type)
The speed sensor type designed exclusively for use with disc brakes is used in combination with
a disc brake rotor with magnet unit (rear wheel only).
1.
Install the disc brake rotor to the wheel.
• Refer to the "Disc Brake" chapter of General Operations for the installation method.
1.5 - 2 N·m
Speed sensor mounting screw
(length 16 mm)
Speed sensor
Clearance between speed sensor
and magnet unit exceeds 17 mm
Spacer
1.5 - 2 N·m
Speed sensor mounting screw
(length 22 mm)
1.5 - 2 N·m
Mounting screw
24