Connecting Of The Control Unit - Siemens SIMATIC 6AV7671-1EA Serie Bedienhandbuch

Quick Start
Note
Don't use a USB-HUB between the computer and the control unit.
Power supply:
Pin Signal
- GND
+ +24 V
4.2.2.

Connecting of the control unit

Principle
The Panel PC Remote Kit version has the control unit and the computer unit in separate
location. The description of the computer interfaces can be found in instruction manual for
Panel PC.
Fig. 13: Control unit with mounted remote device
Beim Panel PC mit Remote Kit sind Bedieneinheit und Recheneinheit räumlich
Panel PC Remote Kit
A5E00447267V
All manuals and user guides at all-guides.com
The remote device will be delivered in two versions 24 VDC or
100-240 VAC.
For the 100-240 VAC version the power cable is supplied.
24 VDC has special connector; the label on the remote device describes
the pin setting. The pins are specified as follows:
Description
Voltage input GND
Voltage input +24 VDC
08.07
Mounting hole for
fixation of the cable
tie
45
Doc.No.:b40013de1.doc