Connecting; Overview - Siemens SIMATIC 6AV7671-1EA Serie Bedienhandbuch

Quick Start
4

Connecting

4.1.

Overview

Introduction
After the mounting the unit will be connected.
Warning
!
Do not touch power lines or data transmission lines during electrical storms and do not
connect any cables.
Do always unplug the power supply for complete disconnection of the power.
Caution
Sequence of the connection
To avoid a damage of the device, take care about the sequence of the connecter.
Start up
Before connecting the device have to be adjusted to ambient temperature. Don't put the
device in direct heat radiation. At condensation after the waiting time of 12 hours the
device can be switched on.
Risk of data loss
Don't switch of the power supply if the device operates. Disconnect the power supply
after proper shut down of the unit.
Condition
• The device is installed EMC-compatible.
• The device is installed according the manual.
Procedure
1. Connecting the potential equalisation
2. Connecting I/O devices
3. The control unit of the PC Remote Kit is connected to the computer unit with the
supplied cables. (see chapter 4.2.2)
4. Connecting the power supply
Panel PC Remote Kit
A5E00447267V
All manuals and user guides at all-guides.com
Connecting control unit see chapter 4.2.2
-
- Connecting PS/2 mouse
Connecting serial mouse
-
Connecting PS/2 keyboard
-
- Connecting USB devices, e.g. USB mouse
Connecting printer
-
08.07
43
Doc.No.:b40013de1.doc