Recline Position - Concord trimax Einbau- Und Bedienungsanleitung

Selection of suitable shoulder strap height
The height of the shoulder straps must be adjusted to
the body size of the child. The belts should be threaded
through the slots in the back rests as close to the shoulder
height of the child as possible.
As a guide to this:
• Bottom shoulder strap slots for children up to approx.
1,5 years of age
• Middle shoulder strap slots for children up to approx.
2,5 years of age
• Top shoulder strap slots for children up to approx.
3,5 years of age
Fig. 11
The pads are removed by pulling them over the belts
and then disconnecting them from the yoke at the rear
of the seat.
To re-position the seat belt they have to be taken out
through the back rest. If you adjust the height of the seat
belts you also have to adjust the height position of the
pads to the same height.
Fig. 13 For conversion purposes, the belt pads (model b.) in the
backrest are pulled out backwards.
Fig. 14
For installation the pads are pulled through the back rest
from the back afterwards the harness system has to be
thread through the belt pads and the back rest and be
reattached to the yoke at the back of the seat.
Please make sure that the seat belts are the same height
Fig. 15, 16
position and not twisted.

Recline position

The Trimax can be placed in a sitting or in a reclining
Fig. 5,6
position, the reclined position is reached by pushing the
release bar downwards and pulling the seat in a forward
direction until it is fi rmly fi xed.
To return to the upright position, push the adjusting handle
and slide the seat backwards.
GB
4