Hama 00012089 Bedienungsanleitung Seite 41

Adding a delay
It can be practical to incorporate a time delay
for a command step, for example in order to
account for a warm-up phase for the TV. The
standard delay between the infrared signals
is a half second.
a. When entering the steps (see above),
press the PAUSE button at the place
where you wish to add the time delay. The
prompt VERZOEG.ZEIT? appears.
b. Press the number key that corresponds to
the number of seconds you wish for the
delay (e.g. "3" for a 3 second delay). The
maximum delay is 9 seconds.
Running a macro
a. To run a macro, briefly press the MACRO
button while in normal mode. The
following message appears: MACRO
TASTE..
b. Within 20 seconds, press the number key
on which the macro is stored (1, 2 or 3).
c. While the macro is running, the message
MACRO 1 (or 2 or 3) appears along with
the transmitting symbol.
d. If there is no macro stored on the selected
number key, the message MACRO 1 LEER
appears.
Deleting a macro
a. Perform steps a. through c. as described
in the section. MACRO SET appears.
b. Select LOESCHEN MACRO mode using the
navigation buttons.
c. Press OK. The following message
appears: MACRO:TASTE.
d. Press the number key on which the macro
you wish to delete is stored.
e. The prompt LOESCHEN BEST. appears.
f. Confirm by pressing OK again. WARTEN...
appears followed shortly by the
confirmation message FERTIG.
The remote control then switches to normal
operation mode.
All-off function
You can switch off all programmed devices
simultaneously. Proceed as follows:
a. Press the POWER/ALL OFF button twice in
succession and hold the button down on
the second press for approx. 3 seconds.
b. When you release the button, ALLES AUS
appears and the devices switch off.
Some devices can be switched on and
off with the POWER/ALL OFF button. Such
devices switch on again when the ALLES
AUS function is performed when the device is
already switched off.
39