Hama 00012089 Bedienungsanleitung Seite 40

Deleting commands for all source buttons
Access learn mode as described two
sections previous, steps a. to d. Proceed as
follows:
a. Select LOESCHEN ALLES mode using the
navigation buttons.
b. Press OK. The prompt LOESCHEN BEST.
appears.
c. Confirm by pressing OK again. WARTEN...
appears followed shortly by the
confirmation message FERTIG.
The remote control then switches to normal
operation mode.
Macros
A macro allows you save a command chain
in order to perform several functions in
succession. You can program three macros
and store them on the number keys 1, 2 and 3.
These three number keys are also labelled
with TV, VCR, DVD so that the macros can be
assigned accordingly.
Each macro can comprise up to ten button
commands. A macro can incorporate
different devices. For example, this allows
you to switch on the TV, the selected
transmitter, the video recorder and the record
function simply by pressing the MACRO
button and the selected number key 1, 2 or 3.
The Setup and MACRO buttons cannot be
used for a macro.
If you wish to cancel the macro programming
before completion, press the Setup button.
The macro will then not be stored.
SET
38
SET SET
SET SET
Programming macros
a. Press and hold the Setup button for
approx. 3 seconds until CODE SETUP
appears.
b. Briefly press the Setup button four more
times to access the MACRO- SETUP
menu.
c. Press OK to access MACRO EINST mode.
d. Confirm by pressing OK again.
e. Now select the number key 1, 2 or 3 to
which you wish to save the macro.
f. The prompt MACRO 1 MOD.? appears.
(the number corresponds to the previously
selected number key). Press a source
key for the device with which you wish to
begin the command.
g. The prompt MACRO 1 EING!
(Enter macro 1) appears with the step
number (02 for the second step). Now
perform the function which you wish to
save as a macro. You can press 9 more
buttons, and you can also change devices
by pressing the source buttons.
h. When the step sequence is finished, press
the MACRO button to save the macro.
The macro is automatically saved after
step 10.
The confirmation message FERTIG appears.
X=1,2,3
SET
SET
SET SET
SET