Honeywell IDENTLOC Montage, Anschluss, Anleitung Seite 18

18
6.5.4 Cable bushing
View from bottom
Possible cable bushings
(if necessary, break open)
6.5.5 Glue the sensor to the pane
The glass breakage sensor is glued to the inside of the pane
that requires monitoring.The gluing surface must be free
from dust and grease. Use customary glass cleaners for
cleaning and not spirits
To glue the sensor to the pane, we recommend using our
special gluing sets.
Item no. 032267 Glass/metal gluing set
Glue and hardener.
Please use gluing set 032267 for intrusion
detection systems with VdS attestation.
Item no. 055260 Glass/metal gluing set
Glass/metal glue and activator.
Observe the gluing instructions of the manufacturer.
To ensure simple installation and exact positioning, we
recommend using the gluing gauge.
Item no. 032268 Gluing gauge
Mounting and Connection Instructions IDENTLOC Glass Breakage Sensor
.
Sealed soldering pad
Depending on the installation, the
cables can be routed downward.
(instead of the cable bushings at
the side).
Allow the minimum distance
of 2 cm to the frame (see
Chapter 5)
2 c m
m in .