Range; Installation - Sensor And Transmission Unit - Honeywell IDENTLOC Montage, Anschluss, Anleitung

16
6.4

Range

The transmission range
the installation surface.
For installation surface of
Surfaces of wood or plastic allow an optimum range.
To ensure good transmission, the housing distance of both transmission elements must be
to 5 mm . The maximum admissible distance (10 mm) should not be used if possible. Falling
below 2 mm is not allowed!
For installation surface of
For use on metal surfaces
larly critical. The transmission unit and sensor must therefore, be installed
mounting set, Item no. 030810).
6.5 Installation of sensor and transmission unit
The connecting cable of the glass breakage sensor to the transmission unit may
be shortened
When shortening the cable, allow
space in the cavity for this purpose (e.g. wood constructions), the extra length of
cable can be stored in an enlarged cable borehole.
6.5.1 Connect glass breakage sensor to the transmission unit
These IDENTLOC glass breakage sensors
from the earlier version with the item number 032230 (without index).
The new sensors should not be combined with the transmission units used so far (or
vice versa) as
A borehole of 4 - 6 mm is required for the cable bushing through the wing.
Lay the cable from the sensor to the transmissi-
on unit.
Solder the cable of the glass breakage sensor to
the transmission unit according to the illustration
on the right.
It is not necessary to
polarity.
Keep the soldering procedure as short as
possible so that the plastic is not damaged.
Mounting and Connection Instructions IDENTLOC Glass Breakage Sensor
between transmission unit and sensor element
wood or plastic
metal :
the range is reduced.
but not lengthened
this may lead to problems in the range.
pay attention to the
Surfaces of aluminium or brass are particu-
.
an extra length of reserve.
are equipped with a chip which is different
Solder pad
depends mainly on
at a distance
If there is insufficient
Glass breakage sensor
1-core shielded cable
2
(with
Solder pad