Dimensions; Guidelines - Honeywell IDENTLOC Montage, Anschluss, Anleitung

Mounting and Connection Instructions IDENTLOC Glass Breakage Sensor
6.2

Dimensions

(in mm)
Glass breakage
sensor
The
6.3

Guidelines

Check the following points carefully before installing the sensor and the transmission unit
- Is there sufficient space at the intended installation site for
- When securing the housing, there should
- The installation surface must be
spacers.
- Pay attention to secure attachment.
- Tighten fixing screws evenly and
- The distance at the side
- Distance "a" between the transmission unit and the sensor unit see 6.4 "Range".
- The side offset of the housing should not exceed
- The housing of the transmission unit and the sensor must be installed
another.
- The connecting cable of the transmission unit may be shortened but
- Installation should
Passive glass breakage sensor
Moving part
(e.g. window wing)
Fixed part
(e.g. window frame)
22,5
Lock monitoring with connection cable 032232
cables may be shortened but should
flat.
not too tight
to the next transmission unit must be
not take place in the close vicinity of
a
Transmission unit
250 mm max.
2,5 m max.
not be lengthened!
no mechanical tension
Compensate for unevenness by using e.g. flexible
.
5 mm in all directions.
radio transmission systems.
Sensor unit
To EU
Transmission unit
4,5
9
both sensors?
.
min. 80 mm.
parallel
not lengthened.
max. ±5 mm
15
3
9
to one