Compatible Transmitters - simu T5ZSPHz Originalanleitung

WIRING
2
It is recommended a method of power disconnect for each motor be placed within sight of the
motor to cut power during servicing and facilitate reprogramming.
- Secure the cables to prevent any contact
with moving parts.
- The motor must be installed with a drip
loop to prevent water intrusion.

COMPATIBLE TRANSMITTERS

3
1: 1/5 channels Wall Hz transmitters/
Memory Hz
2: 1/5 channels / SUN Mobile Hz transmitters
3: COLOR MULTI 16/ TIMER MULTI /TIMER
EASY transmitters
4: Windy Hz Accel
5: EOSUN Hz VS
Location of the PROG key on Hz
transmitters:
Do not position the transmitter near metal in order to avoid reduced range.
SET UP
4
If the installation includes several motors, power only 1 motor at a time to prevent cross
programming 4.1.
4.1- Factory mode:
a- Connect the motor to the power supply.
b- Press simultaneously on the "UP" and "DOWN"
buttons of a Hz transmitter. The motor will jog (turns
0.5 second in one direction and then in the other).
Go to section 4.2.
- Pressing the UP or DOWN button for less than 2 s will move the motor in constant pressure mode.
- If you hold the UP or DOWN button for more than 2 s the motor will move automatically in the UP or
DOWN direction. You will then have to stop the motor at the desired end-limit position by pressing the
STOP button.
4.2- Checking rotation direction :
>>
Press on the "UP" button on the transmitter:
a- If the tube turns in the UP direction, go to section 4.3.
b- If the tube runs in the DOWN direction, reverse the rotation direction by pressing the "STOP" button for
at least 3 s until the motor jogs. Confirm that the new rotation direction is now correct. Go to section 4.3.
EN
2/12
>>
a
b
>>
N
L
PE
(12 transmitters max. / 3 sensors max. per motor)
1 2
1
2
>>
OK § 4.3
3 s
3 4
3 4
>>
ON
a- b-
>>
T5ZSPHz
Blue
Brown
Green/Yellow
5
5
>>
§ 4.3