simu T5ZSPHz Originalanleitung Seite 17

SETTING 4: MANUALLY SETTING THE DOWN END LIMIT WITH AUTOMATIC BOTTOM LOCK
SYSTEM AND AUTOMATICALLY SETTING THE UP END LIMIT:
The locking system at the lower end limit may vary depending on the product, but the procedure for setting
the entrance/exit positions of the latches remains the same on all systems.
1
5 s
1- Press simultaneously for 5 s the "UP" and "DOWN" buttons : the motor will jog once normally and then a
second time with a slow jog.
2- Press the « DOWN » button: the product will run down automatically if the button is held for 2 s. Then
press the "STOP" button to stop the product at position (P1), which corresponds to the automatic locking
system's entrance point (the fabric should not be tense).
3- If necessary adjust the position with the "UP" and "DOWN" buttons.
4- Press simultaneously on the « STOP » and «UP » buttons : the motor runs up and stop, putting tension on
the fabric.
5- Run the product to position (P2), which corresponds to the automatic locking system's exit point.
6- Press 2 s on the "STOP" button to confirm the adjustments, the motor jogs. The operation is completed.
Go to section §5.
2
P1
+
> 2 s
5
P2
< 2 s
3
1
P
2
P
6
1
P
2
P
2 s
4
1
P
2
P
EN
5/12