simu T5ZSPHz Originalanleitung Seite 22

END LIMIT ADJUSTMENT
12
12.1- Adjustment of end limits set in manual mode (UP or DOWN) :
UP End limit: SETTINGS 1 & 5 only
DOWN End limit: SETTINGS 1 & 2
only
1- Run the product to the end limit to be modified (Up or Down).
2- Press and hold the "UP" and "DOWN" buttons simultaneously for 5 s until the motor jogs.
3- Adjust the position with the "UP" and "DOWN" buttons.
4- Press 2 s on the "STOP" button to confirm the adjustment, the motor jogs. The new position is memorized.
12.2- Adjustment of DOWN end limit for products with automatic bottom lock set in manual mode:
SETTINGS: 4 & 5 only
1 2
5 s
1- Run the product to the down end limit to be modified.
2- Press and hold the "UP" and "DOWN" buttons simultaneously for 5 s until the motor jogs.
3- Press the « DOWN » button : the product will run up automatically if the button is held for 2 s. Press the
"STOP" button to stop the product at position (P1), which corresponds to the automatic latching system's
entrance point (the fabric should not be tense).
4- If necessary adjust the position with the "UP" and "DOWN" buttons.
5- Press simultaneously on the « STOP » and «UP » buttons : the motor will run up and then stop, putting
tension on the fabric.
6- Run the product to position (P2), which corresponds to the automatic locking system's exit point.
7- Press 2 s on the "STOP" button to confirm the settings, the motor jogs. The new position is memorized.
EN
10/12
1
3
P1
+
> 2 s
6
P2
2
5 s
4
1
P
2
P
7
1
P
2
P
2 s
3 4
5
P1
P1
2 s
1
P
2
P