simu T5ZSPHz Originalanleitung Seite 15

4.3- End limit adjustment:
The procedure used to set the end limits depends on the equipment of the product (see table below):
* The setting Typ 3 is especially suitable for « ZIP screens » with a heavy load bar and a top stop.
SETTING 1: MANUALLY SETTING THE UP AND DOWN END LIMITS (PRODUCT WITH AUTOMATIC
BOTTOM LOCK SYSTEM PROHIBITED):
1
+
> 2 s
1- Press the « UP » button: the product will run up automatically if the button is held for 2 s. Stop the product
with the « STOP » button at the desired limit.
2- If necessary adjust the position with the "UP" and "DOWN" buttons.
3- Press simultaneously on the « STOP » and « DOWN » buttons: the motor will run down.
4- When the product reaches the desired Down end limit, press the "STOP" button.
5- If necessary adjust the position with the "UP" and "DOWN" buttons.
6- Press simultaneously on the « STOP » and «UP » buttons : the motor will run up. Press "STOP" button to
stop the product (Optional).
7- Press 2 s on the "STOP" button to confirm the settings, the motor jogs. The operation is completed Go to
section §5.
End limit
setting typ.
SETTING 1
SETTING 2
SETTING 3*
SETTING 4
SETTING 5
2 3
Product devices
Top stop Locking system at lower end limit
None Manual
-
-
- -
4 5
Heavy
load bar
Automatic
-
-
- -
-
-
6
-
-
-
-
7
2 s
EN
3/12