Identification; Nameplate; Servicing The Product; Maintaining The Product - Grundfos iGRID Montage- Und Betriebsanleitung

4.6 Identification

4.6.1 Nameplate

The information on the nameplate of the building
bypass and building measure point is described
below.
1
Type
2
U
N
3
I Max IP
4
°C
T
amb
5
6
Made in Denmark
Fig. 3 Nameplate
Pos. Description
1 Product name
2 Model
3 Production code
4 Serial number
5 Enclosure class according to IEC
6 Factory code
7 Country of origin
8 Approval marks
9 Min. to max. ambient temperature
10 Min. to max. liquid temperature

5. Servicing the product

5.1 Maintaining the product

The building bypass and building measure point are
maintenance-free.

5.2 Repairing the product

Contact Grundfos or a Grundfos-approved service
partner.
8
7
P. N.
8
P.C.
9
S.N.
P1
10
11
DK - 8850 Bjerringbro Denmark

6. Taking the product out of operation

6.1 Taking the product permanently out of
operation
Be aware of the following when taking the building
bypass and building measure point permanently out
of operation and removing it from the pipes.
WARNING
Hot surface
Death or serious personal injury
- Before starting any work on the product,
ensure that the district heating pipe has
been closed, cooled down and
depressurised.
1. Switch off the power supply.
2. Turn off main taps.
3. Ensure that the pipes are depressurised.
4. Remove pressure and temperature sensors and
re-establish the pipes.
5. Remove the motor actuator and the pipe
sections, and re-establish the pipes.
6. Remove the electronics box.
7. Turn on the main taps.
For disposing of the product, see chapter
9. Disposal.