General Information; Hazard Statements; Notes - Grundfos iGRID Montage- Und Betriebsanleitung

English (GB) Installation and operating instructions
CONTENTS
1. General information
1.1 Hazard statements
1.2 Notes
2. Receiving the product
2.1 Scope of delivery
3. Installing the product
3.1 Installing the building bypass
3.2 Installation of the building measure point
3.3 Antenna
3.4 SIM card
3.5 Finish the installation
4. Product introduction
4.1 Product description of the building bypass
4.2 Intended use of the building bypass
4.3 Product description for the building measure
point
4.4 Intended use of the building measure point
4.5 Using the product
4.6 Identification
5. Servicing the product
5.1 Maintaining the product
5.2 Repairing the product
6. Taking the product out of operation
6.1 Taking the product permanently out of
operation
7. Fault finding the product
8. Technical data
8.1 Temperature
8.2 Enclosure class
8.3 Weight
8.4 Dimensions of electronics box
9. Disposal

1. General information

Read this document before installing the
product. Installation and operation must
comply with local regulations and accepted
codes of good practice.
4

1.1 Hazard statements

The symbols and hazard statements below may
Page
appear in Grundfos installation and operating
4
instructions, safety instructions and service
4
instructions.
4
DANGER
5
Indicates a hazardous situation which, if
5
not avoided, will result in death or serious
5
personal injury.
5
6
WARNING
6
Indicates a hazardous situation which, if
6
not avoided, could result in death or
6
serious personal injury.
7
CAUTION
7
7
Indicates a hazardous situation which, if
not avoided, could result in minor or
7
moderate personal injury.
7
The hazard statements are structured in the
7
following way:
8
SIGNAL WORD
8
8
Description of hazard
8
Consequence of ignoring the warning.
- Action to avoid the hazard.
8

1.2 Notes

8
The symbols and notes below may appear in
9
Grundfos installation and operating instructions,
9
safety instructions and service instructions.
9
9
Observe these instructions for explosion-
9
proof products.
9
9
A blue or grey circle with a white graphical
symbol indicates that an action must be
taken.
A red or grey circle with a diagonal bar,
possibly with a black graphical symbol,
indicates that an action must not be taken
or must be stopped.
If these instructions are not observed, it
may result in malfunction or damage to the
equipment.
Tips and advice that make the work easier.