Setting The Vacuum; Aspiration - Asskea proVisio Serie Gebrauchsanweisung

4 Maintenance

4.3.2 Setting the vacuum

1. Switch on the device by pressing the On / Off button
(Fig. 21(F)).
2. Select the desired vacuum range by pressing the corresponding
button (`Low´, `Medium´ or `High´) on the control panel
(Fig. 21(A, B, C)).
As described in section 4.3.1, the vacuum setting buttons
correspond to certain vacuum ranges.
3. You can perform fine adjustments of the set vacuum via the
EN
additional air opening on the fingertip (Fig. 22).
28
Fig. 22
4. Switch off the device by holding the On / Off button
(Fig. 21(F)) pressed for 1-2 seconds.

4.3.3 Aspiration

1. Perform the aspiration procedure as you were instructed
by specialized personnel.
2. Control the aspiration procedure and the desired vacuum
via the additional air opening on the fingertip (Fig. 22).
3. Decommission the device after the aspiration procedure
according to section 4.4.
Always observe section 3.4 and the important information
on handling the bacterial filter! Ensure that the battery has
sufficient capacity during the aspiration procedure. The battery
status display must signal green or orange. If the display turns
red, the power supply unit must be plugged in immediately.
Only then can aspiration be continued without any interrup-
tion.