Operation; Menu Structure; Dmx Operation; Selecting A Dimmer Curve - EuroLite EDX-4RT DMX RDM Bedienungsanleitung

6. OPERATION

After connecting the unit to the mains, it is switched and ready for operation. Use the display and the control
buttons to make your settings. The unit can be controlled via DMX signal from a light console. In addition, it
is possible to program illumination scenes and chases. To switch off the unit, pull the power plug.

Menu Structure

Indication

DMX Operation

In DMX mode the output voltages can be controlled via DMX signal from 0 % to 100 % with a light console.
For this, the DMX starting address must be adjusted for the first DMX channel. Once a DMX is being
received, the control LED in the display lights up.
1
Press UP or DOWN so many times until "A.001" is indicated in the display. Press ENTER to confirm.
The display will be flashing.
2
Use UP or DOWN to set the starting address.
3
Press ENTER to confirm your settings. The display will be flashing repeatedly to confirm the memory
procedure.

Selecting a Dimmer Curve

There are four dimmer curves available for each channel.
1
Press UP or DOWN so many times until "CurE" is indicated in the display. Press ENTER to confirm.
The third position in the display will be flashing.
2
Use UP or DOWN to select the channel to be adjusted: CH 1 to CH 4 or A for all channels. Press
ENTER to confirm. The fourth position in the display will be flashing.
3
Use UP or DOWN to select the desired dimmer curve. Press ENTER to confirm and save your settings.
4
Repeat the steps 2 and 3 to adjust further channels or press ESC to return to the main menu level.
Function
Set DMX address
Select dimmer curve
Program chase
Run chase
Program scene
Run scene
Manual dimming
Select chase run mode (sound control or auto)
21/28 00094312.DOCX, Version 1.0