Cleaning And Maintenance; Replacing The Fuse; Technical Specifications - EuroLite EDX-4RT DMX RDM Bedienungsanleitung

7. CLEANING AND MAINTENANCE

We recommend a frequent cleaning of the device. Please use a soft lint-free and moistened cloth. Never use
alcohol or solvents!
There are no serviceable parts inside the device except for the fuses. Maintenance and service operations
are only to be carried out by authorized dealers.

Replacing the Fuse

If one of the fine-wire fuses of the device fuses, only replace the fuse by a fuse of same type and rating.
Before replacing the fuse, unplug mains lead.
Procedure:
Step 1: Open the fuseholder on the rear panel with a fitting screwdriver.
Step 2: Remove the old fuse from the fuseholder.
Step 3: Install the new fuse in the fuseholder.
Step 4: Replace the fuseholder in the housing.
Should you need any spare parts, please use genuine parts.
If the power supply cable of this device becomes damaged, it has to be replaced by a special power supply
cable available at your dealer.
Should you have further questions, please contact your dealer.

8. TECHNICAL SPECIFICATIONS

Power supply:
Max. power output:
Max. total current:
Number of channels:
Resistive load/channel:
Max. current/channel:
Number of control channels:
Storable scenes:
Storable chases:
Sound control:
Output sockets:
DMX output:
DMX input:
Dimensions (WxDxH):
Weight:
Please note: All information is subject to change without prior notice. 16.10.2015 ©
DANGER TO LIFE!
Disconnect from mains before starting maintenance operation!
230 V AC, 50 Hz ~
3680 W
16 A
4
1150 W
5 A
4
10
10 with 30 steps each
via built-in microphone
4 safety power outlets
3-pin XLR mounting plug
3-pin XLR mounting jack
270 x 185 x 75 mm
2.3 kg
25/28 00094312.DOCX, Version 1.0