Operation - EuroLite EDX-1805 DMX Bedienungsanleitung

OPERATION

Start your EDX dimmer pack. First "WELCOME TO USE" appears on the LCD display.
After self testing, the unit recalls the previous memory record ("Running Progxx" or "DMX MODE")
Use the buttons below the LCD display to navigate through the menu.
Use the UP and DOWN-buttons to select one of the 5 points of the EDX-1805 DMX.
SEL MODE, DMX ADDR, MANUAL, CURVE, SPEED.
Enter one of the menus by pressing the MENU-button.
Use the UP and DOWN-buttons to set the parameters and confirm with the MENU button.
Exit the individual menu by pressing ESC.
Note! The underscore on the display indicates your position in the menu.
Sel Mode - Operating Mode
Press MENU to enter the first sub-menu, Sel Mode. The display indicates the current mode.
Use the UP and DOWN-buttons to select Prog 01-12 or DMX and press MENU.
Prog 01-12:
DMX:
Dmx addr - Starting Address
Press MENU to enter the second sub-menu, Dmx addr. The display indicates the current mode.
Use the UP and DOWN-buttons to select Single or Block and press MENU.
Single: Set a starting address (001-512) for each channel individually.
Several channels can share the same address.
Block: Set one starting address (001-512) for all 18 channels.
Sel mode
Prog 08
Select the 12 built-in programs. DMX signals are prior to built-in programs.
Press ESC to return to main menu.
Activates DMX-control. Press ESC to return to main menu.
Dmx addr
Block
24/28 70064145_V_1_1.DOC