Addressing The Device; Outputs; Connection With The Mains; Operation - EuroLite AT-DIMM 8 DMX Bedienungsanleitung

Caution: At the last device, the DMX-cable has to be terminated with a terminator. Solder a 120
between Signal (–) and Signal (+) into a 3-pin XLR-plug and plug it in the DMX-output of the last device.

Addressing the device

Set the required DMX-address via the Control Board.
To define the starting address, you have to be in DMX-mode. Press MODE until the display indicates d001.
In DMX-mode, the DMX LED indicator lights up.
Set an address between 001 and 512 via the UP and DOWN buttons.

Outputs

The output sockets are located on the rear panel. Connect your loads via the output-sockets. The maximum
load per channel is 100 W. Please note that the maximum current must never be exceeded.

Connection with the mains

The electric connection must only be carried out by a qualified electrician!
The occupation of the connection-cables is as follows:
Cable Pin
Brown Live
Blue Neutral
Yellow/Green Earth
The earth has to be connected!
If the device will be directly connected with the local power supply network, a disconnection switch with a
minimum opening of 3 mm at every pole has to be included in the permanent electrical installation.
The device must only be connected with an electric installation carried out in compliance with the IEC-
standards. The electric installation must be equipped with a Residual Current Device (RCD) with a maximum
fault current of 30 mA.

OPERATION

After you connected the AT DIMM-8 DMX to the mains, it starts running.
The LC-Display lights up and you can choose the desired mode via the MODE button:

- STAND ALONE-MODE

- AUTO MODE
- DMX MODE
- MASTER/SLAVE MODE
- SOUND CONTROL MODE
STAND ALONE-MODE
Chaser
A chaser is a sequence of different steps that will be called up one after another in a continuous loop. With
the AT DIMM-8 DMX, you can select up to 14 different chasers.
DANGER TO LIFE!
International
L
N
17/36
resistor
00056994.DOC, Version 1.1