Manual Dimming; Rdm Function - Eurolite Edx-4Rt Dmx Rdm Bedienungsanleitung

Manual Dimming

1
Press UP or DOWN so many times until "MAun" is indicated in the display. Press ENTER to confirm.
2
Use UP or DOWN to select the desired channel (ChL 1 to 4). Press ENTER to confirm.
3
Use UP or DOWN to adjust the channel's dimmer value (0 to 255). Press ENTER to confirm and save
your settings.
4
Repeat the steps 2 and 3 to adjust further channels or press ESC to return to the main menu level.

RDM Function

This unit supports RDM (Remote Device Management) and makes remote control of devices connected to
the DMX bus possible. ANSI E1.20-2006 by ESTA specifies the RDM standard as an extension of the
DMX512 protocol. Manual settings like adjusting the DMX starting address are no longer needed. This is
especially useful when a fixture is installed in a remote area.
RDM is integrated in the DMX protocol without influencing the connections. The RDM data is transmitted via
the standard XLR-poles 1 and 2 – new DMX cables are not necessary. RDM-ready and conventional DMX
devices can be operated in one DMX line. The RDM protocol sends own packages in the DMX512 data feed
and does not influence conventional devices.
This unit supports the following RDM commands:
Parameter ID
DISC_UNIQUE_BRANCH
DISC_MUTE
DISC_UN_MUTE
DEVICE_INFO
SUPPORTED_PARAMTETERS
DMX_START_ADDRESS
IDENTIFY_DEVICE
DEVICE_MODEL_DESCRIPTION
MANUFACTURER_LABEL
DEVICE_LABEL
DMX_PERSONALITY
DMX_PERSONALITY_DESCRIPTION
SLOT_INFO
SLOT_DESCRIPTION
Discovery
Command
24/28
SET GET
Command Command
00094312.DOCX, Version 1.0