Operation; Setting Into Operation; How To Navigate Through The Configuration Menu; Menu Structure - EuroLite DPX-1210 Bedienungsanleitung

7. OPERATION

7.1 Setting into operation

After connecting the device to the mains, it starts running. "EUROLITE" and "WELCOME TO USE" is
indicated on the display. During this indication, the unit is conducting a self-test and recalls the previous
memory record afterwards, "Running Prog" or "DMX MODE". If the unit receives a DMX signal, the DMX
indicator lights up. You are now in the configuration menu.

7.2 How to navigate through the configuration menu

In the following subchapters every menu point is described in detail. Use the buttons below the LCD to
navigate through the menu and for data input. The underscore on the display indicates your position in the
menu.
By pressing the buttons UP/DOWN, you can select the 6 menu points on the main level of the configuration
menu: DMX Fail, Pha Corr, DMX Addr, Preheating, Curve, Preset. Enter one of the menu points by pressing
the button MENU. You are now in the corresponding submenu. By using the buttons UP/DOWN you can set
the parameters. The values can be increased or decreased by 1. Keep the buttons UP/DOWN pressed for
two seconds to change the values faster. Exit the individual menu by pressing ESC. Thus your settings will
be saved. The setting procedure will be stopped if no button is actuated in the submenus for 20 seconds.
The unit automatically returns to the main level of the configuration menu.
All adjustments made in the configuration menu remain stored even when the unit is powered off and on.

Menu structure

Level 1 Level 2
DMX Fail Hold
Analog
Prog 1-12
Pha Corr Yes
No
DMX Addr Block
Single
Preheating All
Single
Curve Linear
Switch
Square
Preset All
Single
Button Function
MENU � Call menu point
UP � Navigation up/data input
DOWN � Navigation down/data input
ESC  Exit menu point
Level 3 Function
Hold last DMX signal
Select analog input
Prog 1-12 Select program 1-12
Speed 0.1-20 s Set program speed
Phase correction on
Phase correction off
Address 1-512 Set DMX address block-wise
Channel 1-12 Set DMX address per channel
Address 1-512 Set channel and DMX address
0-50 % Lamp preheat for all channels
Channel 1-12 Lamp preheat per channel
0-50 % Set channel and preheat value
Dimmer curve linear
Dimmer curve switch
Dimmer curve square
0-100 % Manual control block-wise
Channel 1-2 Manual control per channel
0-100 % Set channel and value
21/24 00051009.DOC, Version 1.4