Operation; Dmx Addressing; Switch Pack Mode - EuroLite EDX-1 MK2 Bedienungsanleitung

OPERATION

Plug the mains cable into an appropriate 230 V power outlet. When powered on the display indicates the last
set DMX address setting. If the power frequency is not stable, the display indicates "AC-0" until the power
supply is more stable. The operating modes can be selected by means of the display and the control
buttons. All settings remain stored even if the device is disconnected from the mains. The unit can be
controlled via DMX signal from a light console. To switch off the unit, pull the power plug.

DMX addressing

Switch pack mode

1. Press the MENU button so many times until the display indicates
mode "A" for DMX addressing. If the last set DMX address was 123, the
display indicates "A 123".
2. Use the UP and DOWN buttons to set the DMX address. Keep UP or
DOWN pressed to scroll through the values faster.
NOTE: Channel output is disabled during DMX address settings.
1. The dimmer pack can be switched from a linear dimming curve to the
Switch Pack mode. Press the MENU button so many times until "d" for
dimming function appears on the left hand side of the display.
2. Press the DOWN button. The display indicates "S".
18/24 00116602, Version 1.0