4.2 Assembly of parts removed for transport
The sliding table saw is delivered pre-assembled. Sliding table, table top extension, rip fence,
miter gauge, and mounting guard and protective cover to be mounted
4.2.1
Place the sliding table to the position on the machine body.
Then set up the terminal screws to the existing holes from. Balance the flatness of sliding
table and the machine table with shims.
Before tightening the screws, adjust the sliding table with stop screws on the horizontal
parallelism.
Then bring it to the rear end plate.
4.2.2
4.2.3
The hood must be installed mandatory. Working with the sliding table saw without
protective cover is forbidden.
HOLZMANN Maschinen Austria
Mounting the slide table
Mounting the protective cover bracket
Mounting of the guard
www.holzmann-maschinen.at
Formatkreissäge / panel saw FKS 400VF-3200
ASSEMBLY
Seite 34