Troubleshooting - Holzmann FKS 400VF-3200 Bedienungsanleitung

7 TROUBLESHOOTING

Disconnect the machine from the power supply prior to any checks performed at the
machine itself!
Trouble
Machine does not start
Burn marks on the workpiece
Velocities different from the
set value
The finished size of the ma-
chined workpiece is incorrect
for the cutting width on rip
fence
Sliding table at end positions
higher than machine table
Workpiece clamped while
advancing
Broken edges on the
workpiece
Arm running smoothly
HOLZMANN Maschinen Austria
Possible cause
Emergency stop switch to
switch off
switch or a phase is broken
Overload protection is
triggered.
Safety fuse is blown
Open cover plate for saw
blades
The blade is blunt
adjusted rulers
Adjusted measurement scale
for the cutting width display
Lower rollers set incorrectly
dull blade
Riving knife thickness does not
match the used blade
The scoring saw is not on the
same line with the main saw
Telescopic tube or track rollers
dirty
www.holzmann-maschinen.at
TROUBLESHOOTING
Solution
Turn the emergency OFF switch
to the right to unlock to
Repair the defective circuit or
the faulty phase
Wait until the engine cools
down
Replace the fuse
Cover plate close
Replace the blade
Make a right the attacks
Setting dimension
workpiece on the rip
measure the workpiece and the
measuring scale move so that
the measured average width is
shown at the edge of the ruler
Adjust the lower rollers
Replace with sharp blade
Splitting wedge thickness must
be greater than or equal to
blade thickness.
Set the scoring saw a new
telescopic tube or track rollers
clean
Check wipers
Formatkreissäge / panel saw FKS 400VF-3200
scale: cut
fence,
Seite 44