Preparation Of The Surface; Assembly Of Parts Removed For Transport; Mounting The Slide Table; Mounting The Outrigger Table - Holzmann FKS 305VF-2600 Bedienungsanleitung

14.1.4

Preparation of the surface

Eliminate the preservative, which is applied for corrosion protection of the parts without
painting. This can be done with the usual solvents. Here no nitro solvent or similar means,
and in no case use water.
The use of paint thinners, gasoline, corrosive chemicals or abrasive cleaners will result
in damage to the surface!
Therefore:
When cleaning, use only mild detergent


14.2 Assembly of parts removed for transport

The sliding table saw is delivered pre-assembled. Sliding table, table top extension, rip fence,
miter gauge, and mounting guard and protective cover to be mounted
14.2.1

Mounting the slide table

 Place the sliding table to the position on the machine body.
 Then set up the terminal screws to the existing holes from. Balance the flatness of sliding table
and the machine table with shims.
 Before tightening the screws, adjust the sliding table with stop screws on the horizontal paral-
lelism.
Then bring it to the rear end plate.
14.2.2

Mounting the outrigger table

 Screw at the beginning of the sliding table bracket with the
threaded rod of the swing arm.
 Push the sliding table with a boom with the T-slot screws in
the sliding table you.
 The sliding table bracket is screwed to the desired position
with the sliding table.
 The sliding table boom on the threaded rod to the same lev-
el of machine and sliding table set.
HOLZMANN Maschinen GmbH www.holzmann-maschinen.at
N O T E
Formatkreissäge / panel saw FKS 305VF-2600 / 3200
ASSEMBLY
Seite 31