Holzmann FKS 400VF-3200 Bedienungsanleitung Seite 42

In some cases, it is the cutting of laminated boards required before using the
scoring blade to prevent the demolition of the cutting edge with the main saw
blade.
The scoring saw blade must be adjusted in
height so that a slot with a depth of 1 - 1.5
mm results
Notes of using the circular saw
Set the guard of the saw blade.

Carry out the work evenly, without relapses and without take it back to the end of

the cutting.
Set the saw blade so high that the ring gear is really reliably covered by the protec-

tive cover (distance between the protective cover and the workpiece - max. 5 mm
Perform the adjustment of the saw blade height and tilt only with the machine

switched off.
Work only with good grounds tools
Use the push rod at the end of cutting when the distance between the circular saw

blade and the parallel ruler is less than 120 mm.
Make sure that the machine is working without vibrations.

Cracked and deformed saw blades can not be repaired. You need to be sorted out

immediately as a committee and be replaced by ordinary.
For repair and maintenance of circular saw blades with soldered fins (eg soldering

new cutting blades) the construction of the circular saw blades (tooth shape, tooth
width) must not be changed. The circular saw blades with soldered fins can be
grinding up to minimum dimensions of the plate of 1 mm
Then the circular saw blade must be removed from service.

Select the number of teeth of the saw blade so that at least 2-3 teeth working sim-

ultaneously). If only one tooth works, a poor working surface is, the danger of the
vibrations and noise pollution from increased setback increase.
HOLZMANN Maschinen Austria
.
www.holzmann-maschinen.at
Formatkreissäge / panel saw FKS 400VF-3200
OPREATION
Seite 42