Electrical Connection Of The Machine - Holzmann TS 250FL Bedienungsanleitung

blade guard and housing connection forms. Now connect the hose of the already mounted in the
interior of the housing through the round opening of the housing. Insert the thin tube to the blade
guard and connect it again with the other end of the plastic fastener (see picture). The connecting
element now with the previously pulled the hose from the machine, tighten the clamp. Through
the connecting element, the machine can now be connected to your extraction.

9 ELECTRICAL CONNECTION OF THE MACHINE

The electrical connection must be carried out exclusively by a qualified professional.
Abb. 16
If the connector on your machine is not already installed, the machine can be con-
nected according to the following wiring diagram.
Make sure that the phases show proper contact.
Abb. 17
Improper connection of the phases can not guarantee to be invoked.
10 CHANING THE SAW BLADE
Always wear work gloves to move the saw blade to avoid injury.
Procedure:
Abb. 19
Abb. 20
10. The gap wedge (b) must be set so that it at a distance from the sawblade
HOLZMANN Maschinen Austria
1. Unplug the machine from the excitation voltage.
2. Remove the blade guard
3. Lower the saw blade in the lowest position
4. Remove the eight screws on the blade cover (a) and remove the cover.
5. Raise the saw blade it is now in the top position
6. In order to secure the blade to twist the screw out of the jam nut, look for
the hole in the disc and insert the retaining bolts in this.
7. Now with the wrench, the nut can be screwed down.
8. Take now the nut, washer and blade off of the drive shaft.
9. Now insert the new blade into the drive spindle and fix this in reverse order
as described on the picture.
is 3-8mm. The distance can be solved by the screw (a).
www.holzmann-maschinen.at
Abb. 18
W A R N I N G
Seite 28
Formatkreissäge TS 250FL