Automatic Operation - RADEMACHER RolloTron Basis DuoFern1200 Original - Betriebs- Und Montageanleitung

15. Automatic operation

AUTO
The RolloTron Basic DuoFern 1200 supports the follow-
ing automatic functions:
◆ Automatic timer
◆ Automatic dusk function
◆ Automatic dawn function
◆ Automatic solar function
The automatic functions must be activated first in
the DuoFern controller
The automatic functions are only available if the RolloTron
Basic DuoFern 1200 is operated with a DuoFern controller
(e.g. DuoFern central operating unit, HomePilot®, etc.),
see page 80, and the functions were activated in said
DuoFern controller.
Note for switching the automatic functions on/off
All of the automatic functions can be switched on and
off together on the RolloTron Basic DuoFern 1200, see
page 85.
i
Once automatic functions are deactivated, it is
only possible to operate the system manually.
Automatic timer
Execution of control signals from the DuoFern
network
If the automatic timer is activated, control signals for
opening and closing times will be received from the
DuoFern network and executed by the system.
Executing a closing command
The DOWN command in the DuoFern network causes
the roller shutters to close to their lower end point or
to the configured ventilation position, see page 84.
Executing a random function
If the RolloTron Basic DuoFern 1200 receives a control
signal from a DuoFern transmitter with activated random
function (e.g. from a HomePilot®), then it is also able
to execute the random function. The random function
enables a random delay of up to 30 minutes.
i
The random function cannot be switched
on/off on site.
EN
83