System Configuration; Encryption/Decoding System - TechniSat DIGIT MF4-K CC Handbuch

(Fig. 8-24)
8.5.4 Copying the settings
You have the facility to copy all the settings, such as pro-
gramme list, antenna settings, etc. of your digital receiver
(sender) to another digital receiver (receiver) of the same
type, and using the same version of the operating software.
(Fig. 8-24)
> To do this, connect the two receivers by means of a
null modem cable.
> Switch on the (destination, receiving) receiver.
> To copy the settings, press any operating key on the
(source, sending) receiver.
The settings of the source receiver will now by trans-
mitted to the destination receiver. Please note any
messages displayed on screen.

8.6 System configuration

Use this menu item to view the specific receiver data
(e.g. current software version).
> Use the arrow keys up/down to mark this line in
the sub-menu Settings.
> Confirm by pressing OK.
> Press the Menu key to return to normal operation.

8.7 Encryption/decoding system

This menu point takes you to the sub-menues for the
Smartcard used, and for the CI module. You can view infor-
mation related to the Smartcard or the CI module used by
selecting the Smartcard or the CI interface, by pressing the
arrow keys, then confirm by pressing OK.
Manual Initialisation of the CI module
> You can initialise the CI module manually by pressing
the red function key CI Reset.
110