Configuring Favourites List - TechniSat DIGIT MF4-K CC Handbuch

7.16.5 Programming a new timer event
> To programme a new timer event, use the arrow
keys up/down to mark a blank line in the menu
Timer overview.
> Press the yellow function key New to go to the entry
window allowing you to programme a new timer event.
Complete this in accordance with Point 7.16.1.
> Use the arrow keys up/down to mark the additio-
nal window displayed: Type.
> Confirm by pressing OK. A window showing the timer
types available will be displayed.
> Use the arrow keys up/down to select the desired
timer type.
> To accept the timer type, confirm by pressing OK.
> When you have completed the programming, press
the yellow function key Accept to accept the data
into memory.
Please note!!!
Please ensure that the receiver has acquired the time. This
will be shown in the display while the unit is in stand-by
mode. If this is not the case, leave the receiver switched on to
a major programme such as ZDF for approximately 30
seconds, so that the receiver can acquire the current time.
Now the time should be shown in the display while the recei-
ver is in stand-by mode (provided this was activated in Point
6.2.4).
8 Changing the basic programming
8.1 Configuring the Favourites list
This chapter describes how you can change the pre-program-
ming of your digital receiver as well as the Favourites pro-
gramme list in accordance with your own preferences. This
function is also required to sort newly found programmes into
the programme list
after a programme scan has been performed.
In this regard you should know the following: your receiver is
equipped with two programme lists, the Favourites list
and the Total list. The Favourites programme list includes
all the programmes you have accepted into the list according
to the procedure described below. The Total list includes all
programmes.
94