TechniSat DIGIT MF4-K CC Handbuch Seite 71

The initial installation procedure described here serves mere-
ly as an example. The exact initial installation procedure will
depend on the settings you select. Please therefore follow
the instructions displayed on screen closely.
Operating language
> Press the OK key to open the display window for the
Operating language. (Fig. 5-2)
> Use the up/down arrow keys to select the desired
operating language.
> Confirm by pressing OK.
Audio language
> Use the up/down arrow keys to select the prefer-
red audio language. (Fig. 5-3)
Once the installation assistant has been completed,
the sorting of programmes in the Favourites list will be
made in accordance with your selection.
> To accept the selection, confirm by pressing OK.
Country selection
> Use the arrow keys up/down to select the time
zone corresponding to your country of residence.
(Fig. 5-4) The time will be set automatically depending
on your selection.
> Confirm by pressing OK, to accept your selection,
and proceed to channel selection.
Scanning for programmes
> Use the arrow keys up/down to mark the field All
channels, if you wish to scan for both encrypted and
unencrypted programmes, or mark All unencryp-
ted channels, if you wish to scan only for unencryp-
ted programmes. (Fig. 5-5)
> When you confirm the scan by pressing OK, an auto-
matic programme scan will be performed. This type of
scan entails automatically scanning the entire recep-
tion range of the receiverfor digital programmes. The
programmes found will be automatically stored in the
Favourites list. This procedure may take several minu-
tes. Please note any additional messages displayed
on screen.
71
(Fig. 5-2)
(Fig. 5-3)
(Fig. 5-4)
(Fig. 5-5)