Changing Unit Pin; Mode; Programme Scan - TechniSat DIGIT MF4-K CC Handbuch

8.3.2 Changing the unit PIN
The unit PIN is set to a default setting of 0000 at the factory.
> Press the OK key. The menu used for changing the
unit PIN code will be displayed. (Fig. 8-12)
> Now use the numeric keys to enter the current unit
PIN code. (Default setting 0000)
> Use the numeric keys to enter the new unit PIN
code.
> Repeat the entry.
> When you have completed changing the unit PIN
code in this manner, you will automatically be taken
back to the parental control menu.
Note!
Do not forget your unit PIN code. If you do forget it at som
point, please consult your retail specialist!

8.3.3 Mode

> In this line, use the arrow keys left/right to switch
the parental control On or Off
8.4 Programme scan (search)
Please note:
The cable network within which your receiver is operating will
determine which programmes can be received. Your cable
network operator will provide information on the programmes
available.
For your receiver to receive and reproduce the digital pro-
grammes available in the cable network, u will have to per-
form a programme scan (search). There are various options
for performing a programme scan.
1. Automatic scan
Select this type of scan in order to search the entire frequen-
cy range of the receiver for programmes.
2. Expanded scan
Select this type of scan in order to search a specific frequen-
cy or channel range for programmes, or in order to perform a
network scan.
3. Manual scan
Select this typer of scan to search a specific frequency for
programmes.
103
(Fig. 8-12)