Dolby Digital (Ac3); Operation; Switching On And Off; Selecting A Programme - TechniSat DIGIT MF4-K CC Handbuch

6.3.6 Dolby Digital (AC3)

Various movies are broadcast in Dolby Digital format. This is
indicated by display of the Dolby logo
window, once the programme has been selected.
If you have a Digital 5.1 channel amplifier, you can, where
available, enjoy 5.1 channel Dolby Digital sound with specific
movies. The only requirement is that the digital output Audio
Out Digital (see Point 4.5.2) of your DVB receiver must be
connected with the digital input of your Dolby Digital 5.1 chan-
nel amplifier.
If a programme is being broadcast in Dolby Digital sound, this
will be indicated by display of the Dolby logo in the informa-
tion box when you switch to the programme. If the Dolby
Digital function (AC3) is activated (on), these programmes
will automatically be reproduced in Dolby Digital format.
If the function is not activated (off) , Dolby Digital sound can
also be switched on manually. Please also note Point 7.6.1 of
the operating manual.

7 Operation

7.1 Switching on and off

> Switch the digital receiver on by pressing the
On/Standby key, either on the receiver or on the
remote control.
> Press the same key again, either on the receiver or on
the remote control, to switch it off again.
> The receiver is now in stand-by mode, and the time
will be shown in the display of the receiver (if activated
as per Point 6.2.4).
If the current time is not displayed, this must still be
acquired by the receiver. To do this, switch the unit on,
and set it to receive a major channel such as ZDF for
about 30 seconds, during which time the clock setting
will be automatically acquired.

7.2 Selecting a programme

7.2.1 Using the Programme up/down keys

> You may use the programme keys up/down eit-
her on the receiver or on the remote control to switch
up or down one programme slot at a time.
76
in the information