Assembly Of The Appliance - Grundig Hood GDK 4382 B Handbuch

ASSEMBLY OF THE APPLIANCE

Assembly Preparation of the
Hood onto the Wall
Mark the surface where assem-
bly template is going to be hung. (
Figure 1)
Affix the installation template onto
the installation place of the hood.
(Figure 2)
12
Perforate a hole with Ø 8 mm drill
on marked points. (Figure 3)
4
Hammer 3 Ø 8x40 mm dowels on
perforated holes. Screw 2 Ø 5x45
mm hanging screws to dowels
hammered above. There must be
a gap of 5 mm between the screw
head and the wall. (Figure 4)
4
50