Replacement Of Lamp - Grundig GDSP 2460 BC Benutzerhandbuch

OPERATION OF THE APPLIANCE ______________________
If you want the appliance to stop automati-
cally, you need to enable the automatic stop
feature again.

Replacement of Lamp

(Figure 3)
Make the electrical connections of the appli-
ance. Your appliance uses 3W spot LED lamp.
For replacing the lamps, push downwards
on the holder from its behind, turn it coun-
ter-clockwise, and take it out downwards.
Apply the above operation in reverse to install
new lamps (Figure 3).
Bulb
Bulb Power (W)
Holder / Socket
Bulb Voltage (V)
Size (mm)
ILCOS Code
3
GZ 10
220 - 240
53 x 50
DR/F3-220-240-
GZ10-50-53
Operation with Chimney
Connection
Vapour is extracted through
■
the flue duct, which is fas-
tened to the connection head
on the hood.
The diameter of the flue
■
duct must be the same as the connection
ring. In horizontal settings, the pipe has to
have a slight upward slope (around 10º) so
that the air can exit the room easily.
Operation without Chimney
Connection
Air is filtered through the
■
carbon filter and recirculated
in the room. Carbon filter is
used when it is impossible to
use a flue in the house.
In flueless use, remove the flaps inside the
■
flue adapter.
Remove the aluminium grease filter. To in-
■
stall the carbon filter, fit the filter to the tabs
by centring it on the plastic piece on both
sides of the fan body. Tighten it by turning
right or left.
Replace aluminium grease filter.
■
ENGLISH 9