Sabo 72-12G Betriebsanleitung Seite 131

TROUBLESHOOTING
PROBLEM
5. Weak engine
performance dur-
ing cutting
6. The engine
stops but the
light flashes
7. The engine
stops and the
light goes off
8. The engine
stops but the
light stays on
9. Uneven cut
and poor grass
collection
Downloaded from www.Manualslib.com
SITUATION LIKELY CAUSE
Key in «ON», – forward speed too high in relation
engine running to cutting height
Key in «ON», – the safety devices cut in
engine running
Key in «ON», Electronic card in safety alert, due
engine running to:
– earthed micro-switches
– flat battery
– overload caused by the charge
regulator
– badly connected battery (poor
contact)
– engine badly earthed
Key in «ON», – problems in the engine
engine running
Key in «ON», – cutting deck not parallel to the
engine running ground
– blade cutting badly
– forward speed too high com-
pared to height of grass
– collector channel is obstructed
– cutting deck full of grass
manuals search engine
ENG 41
SOLUTIONS
– reduce the forward speed
and/or raise the cutting
deck
– check that the conditions
allowing starting are met
(see page 26/b)
Put the key in the «OFF»
position and look for the
cause of the problem:
– check connections
– recharge battery
– consult your Dealer
– check battery connections
– check engine earth connec-
tion
– consult your Dealer
– check tyre pressures
– re-align the cutting deck to
the ground
– check that the blade is fitted
properly
– sharpen or replace the
blade
– check the tension of the
belt
– reduce forward speed
and/or raise the cutting
deck
– wait for grass to dry
– remove the grass-catcher
and empty the collector
channel
– clean the cutting deck