Aquaclean Installation; Aquaclean Replacement - Saeco Incanto HD8914 Handbuch

10.2.1 AquaClean installation

WATER
FILTER
0/8
ON
0/8

10.2.2 AquaClean replacement

WATER
FILTER
8/8
START
CALC
CLEAN
Incanto_AMF_EN-IT-DE_Rev01.indb 21
> Remove the AquaClean water filter from its packaging, immerse it vertically in cold
water, with the opening upwards, and slightly press the sides to let air bubbles out.
>
Insert the AquaClean water filter in the empty water tank. You can leave the small
water filter installed.
>
Push the AquaClean water filter to the lowest possible point.
>
Fill the water tank with fresh water and restore it to the machine.
>
Dispense half the water contained in the tank as detailed in the "6.4.1 Hot water
dispensing" chapter.
>
Fill the water tank again.
Machine setting phase during the installation
Press the MENU button and scroll the menu to go to the 'AquaClean Filter function'.
>
>
Press the OK button to select the function.
The machine will indicate the number of filters which have been used from 0 up to
8 filters.
Press the OK button to confirm the activation otherwise
>
Press the ESC button to exit the programming function.
The machine automatically exits the programming mode if no button is pressed for
3 minutes.
The machine is ready for brewing. The AquaClean filter is active.
The number of filters used is automatically updated. After the 8th filter the counting
will restart from 0/8.
After a period of usage the 'AquaClean water filter' signal starts blinking (for
approx.150 products of 100ml). This means that you have to replace it.
The signal will blink faster when it comes close to the expiring time.
Take out the used filter and follow the steps described in chapter "10.2.1 AquaClean
>
installation" chapter.
If you don't replace the filter on time, the machine will ask you to perform a descaling
cycle.
>
In ths case, follow the steps as described below "AquaClean filter replacement after
8 filters used".
AquaClean filter replacement after 8 filters used
> Press the MENU button and scroll the menu to go to the 'AquaClean Filter function'.
>
Press the OK button to select the function otherwise
Press the ESC button to exit the programming function.
The machine automatically exits the programming mode if no button is pressed for
3 minutes.
The machine needs to be descaled as the series of 8 filter is over.
> Perform the instructions described at the "7.5 Descaling cycle" chapter otherwise
Press the ESC button twice to exit the programming function.
The machine automatically exits the programming mode if no button is pressed for
3 minutes.
At the end, the machine goes back to the main menu.
>
When the main menu is displayed, to replace the filter proceed as described in the
previous "10.2.1 AquaClean installation" chapter.
The machine will restart the counting of the 8 filter series from 0/8.
21
ENGLISH
27/03/15 09:58