Replacing The Power Cable; Cleaning, Maintenance And Ordering Of Spare Parts - EINHELL TC-TS 200 Originalbetriebsanleitung

8.1.2 Cutting very narrow workpieces (Fig.
16)
•
Be sure to use a push block when making
longitudinal cuts in very narrow workpieces
with a width of 50 mm and less.
•
The low guide face of the parallel stop is best
used in this case.
•
There is no push block supplied with the saw!
(Available from your specialist dealer) Repla-
ce the push block without delay when it beco-
mes worn.
8.2 Making angular cuts (Fig. 13/17)
Angular cuts must always be made using the par-
allel stop (7). If you tilt the saw blade (4) to the left
when making angular cuts, position the parallel
stop (7) on the right-hand side of the saw blade
(4). Guide the workpiece between the saw blade
(4) and the parallel stop (7).
•
Set the blade (4) to the desired angle. (See
7.4.)
•
Set the parallel stop (7) in accordance with
the workpiece width and height (see 7.2)
•
Carry out the cut in accordance with the work-
piece width (see 8.1.1 and 8.1.2).
8.3 Making cross cuts (Fig. 18)
•
Slide the cross stop (14) into the slot (21)
in the table and adjust to the required angle
(see 7.3).
•
Press the workpiece firmly against the cross
stop (14).
•
Switch on the saw.
•
Push the cross stop (14) and the workpiece
toward the blade in order to make the cut.
•
Warning!
Always hold the guided part of the workpiece.
Never hold the part which is to be cut o .
•
Push the cross stop (14) forward until the
workpiece is cut all the way through.
•
Switch off the saw again. Do not remove the
offcut until the blade has stopped rotating.

9. Replacing the power cable

Danger!
If the power cable for this equipment is damaged,
it must be replaced by the manufacturer or its
after-sales service or similarly trained personnel
to avoid danger.
GB
10. Cleaning, maintenance and
ordering of spare parts
Danger!
Always pull out the mains power plug before star-
ting any cleaning work.
10.1 Cleaning
•
Keep all safety devices, air vents and the
motor housing free of dirt and dust as far as
possible. Wipe the equipment with a clean
cloth or blow it with compressed air at low
pressure.
•
We recommend that you clean the device
immediately each time you have finished
using it.
•
Clean the equipment regularly with a moist
cloth and some soft soap. Do not use
cleaning agents or solvents; these could at-
tack the plastic parts of the equipment. Ensu-
re that no water can seep into the device. The
ingress of water into an electric tool increases
the risk of an electric shock.
10.2 Maintenance
There are no parts inside the equipment which
require additional maintenance.
10.3 Ordering spare parts and accessories
Please provide the following information when
ordering spare parts:
•
Type of unit
•
Article number of the unit
•
ID number of the unit
•
Spare part number of the required spare part
For our latest prices and information please go to
www.isc-gmbh.info
Tip! For good results we
recommend high-quality ac-
cessories from
www.kwb.eu
welcome@kwb.eu
10.4 Transport
Only ever transport the machine by lifting it by the
saw table. Never use the safety devices such as
the saw blade guard and stop rails for handling or
transporting purposes.
- 25 -
!