Adjusting The Water Hardness - hanseatic HGVI6082D14J7713GS Gebrauchsanleitung

To adjust the door
– so that it is easier to access, turn the screws
in an anticlockwise direction.
– so that it is more difficult to access, turn the
screws in a clockwise direction.
Water hardness
Determine water hardness
In order to determine the water hardness in
your place of residence, you can
– look on the website of your water provider.
– telephone your water supplier.
– purchase suitable test strips at the
pharmacy.
Water hardness in
your household in
°dH
0-5
6-11
12-17
18-22
23-34
35-55
1. Obtain the appropriate setting from the
table above.
2. Open the dishwasher door.
Set-up, connection and initial start-up
Water hardness in
the dishwasher
H1
H2
H3
H4
H5
H6

Adjusting the water hardness

Do not allow more than 1 minute to elapse
between the following steps, otherwise the
setting process will be interrupted.
1. Switch on the dishwasher using the
button (1).
(5)
2. Press and hold the P button (5) for as long
as required until the current water hard-
ness is shown on the display:
3. Press the P button (5) as often as
required until the desired setting is
displayed.
4. Switch the dishwasher off using the
button (1).
The hardness level setting is saved.
Test run
It is recommended that you carry out a test
run before the first dishwasher cycle in order
to remove residues from the manufacturing
process and in order to ensure that the device
functions perfectly.
If no water escapes during the test run and if
there are no unusual noises, the appliance is
ready to use.
Carry out this test run when the dishwasher is
empty and without any dishwasher detergent.
For the procedure, see chapter "Dishwasher
operation", from page EN-22.
Page EN-33
(1)
to .
H1 H6