Mounting The Front Panel - hanseatic HGVI6082D14J7713GS Gebrauchsanleitung

Page EN-32 Set-up, connection and initial start-up
11. Screw the dishwasher to the kitchen unit.
– If you have granite worktops, remove
the internal side cover caps (e) and
screw the dishwasher to the adjacent
kitchen cupboards.
Re-cover the screws (k) with the cover
caps.
– For all other worktops, screw the
mounting bracket (f) firmly to the work
surface.

Mounting the front panel

You can mount a stainless steel front pan-
el on the dishwasher door, or another front
panel design which matches your kitchen.
The front panel must not exceed a weight
of 7 kg.
1. Lay the supplied drilling template on the
reverse side of the front panel in such a
way that the drilling template and the front
panel are flush at the top.
2. Transfer the drill holes from the drill tem-
plate to the front panel.
3. Drill the drill holes in the indicated posi-
tions using a (Ø 2 mm) drill bit.
(h) (g) (l)
4. Affix both installation hooks (h) with four
screws (l) each onto the front panel.
5. Affix both mounting pegs (g) using the
screws (j) onto the front panel.
6. Hang the front panel on the door of the
dishwasher, hold it in place and open the
door carefully.
(i)
(j)
7. Remove the 4 screws from the inside of
(g)
The front panel is then mounted.
(h)
Adjusting the door's
accessibility
You can adjust how easy or difficult it is to
open the dishwasher door. This setting is of-
ten required after the front panel has been
mounted. You can change the spring force of
the door by turning both lower screws.
the door. Screw the front panel in place
at these positions using the 4 enclosed
screws (i).
(i)