Taking Out Of Service - Marzhauser Sensotech SensorReady 3D Betriebsanleitung

Taking out of Service

11 Taking out of Service
X
NOTICE
Possible equipment damage through putting into/taking
out of service with existing mains power connection.
Disconnect the SensorReady 3D from the mains before connec-
ting/disconnecting measuring systems, a PC or other periphe-
rals to/from the SensorReady 3D.
1 Disconnect the power supply of the SensorReady 3D from
2 Disconnect all connected cables from the SensorReady 3D.
3 Clean the SensorReady 3D.
Taking out of service is now complete.
94
Taking SensorReady 3D out of service
the mains.
»
Chapter 8 Maintenance, page 88
Operating Manual