Putting Into Service; Putting Sensorready 3D Into Service - Marzhauser Sensotech SensorReady 3D Betriebsanleitung

SensorReady 3D
5

Putting into Service

5.1 Putting SensorReady 3D into Service

5.1.1 Connecting Measuring System 1 and 2
NOTICE
Possible equipment damage through putting into/taking
out of service with existing mains power connection.
Disconnect the SensorReady 3D from the mains before connec-
ting/disconnecting measuring systems, a PC or other periphe-
rals to/from the SensorReady 3D.
Incorrect data transmission through unshielded cables
possible.
Only use shielded cables for connecting measuring systems, PCs
and other peripherals.
X
1 Read and make sure you understand the Safety chapter
2 Read and make sure you understand the operating ma-
3 Ensure that the SensorReady 3D has a secure footing and is
4 Ensure that the SensorReady 3D is not connected to the
Putting SensorReady 3D into service
before you start set-up and putting into service.
»
Chapter 4 Safety, page 67
nual of the peripherals you would like to connect the
SensorReady 3D to.
mounted stably.
mains.
Putting into Service
71